RF Power Measurement

The HP 53150 Series has an advanced sampler that integrates a separate zero bias Schottky diode for the accurate measurement of input power. This allows measurement of both frequency and power with a single connection. No compromise in frequency coverage ultra-wideband for this capability. The ultra wideband microwave input covers the entire RF and microwave spectrum, from intermediate frequencies (IFs) of 50 MHz to millimeter waves.

The 8482A power sensor is designed for use with the 435A/B, 436A, 437A, 438A, 70100A, EPM series, EPM-P series, E1416A, N1911A, N1912A, N1913A, and N1914A power meters. The 8482A provides extraordinary accuracy, stability, and lower SWR.

Compatible with the 435B, 436A, 437B, 438A, 70100A, E4416A, E4418A/B and E4419A/B power meters
Excellent SWR above 600 kHz for reducing mismatch uncertainty
2.4mm (m) connector as standard

Keysight 8487A thermocouple power sensor is designed for use with the EPM series, EPM-P series, 70100A, E1416A and the 43x series power meters, and provides extraordinary accuracy and stability. The 8487A power sensor also gives you extremely low SWR even at mm-wave frequencies.

10 MHz to 18 GHz, -70 to +20 dBm

The Keysight E-Series diode power sensors are a wide dynamic range (90 dB max) which operate with the EPM and EPM-P series of power meters.

20 Msample/s per second sampling rate

20 Msample/s per second sampling rate

200 readings per second

3.0m / 10 feet

Keysight E9300B Average Power Sensor, 10 MHz to 18 GHz, -30 to +44 dBm
The Keysight E9300B wide dynamic range, 10 MHz to 18 GHz, average power sensor is designed for use with the EPM and EPM-P series power meters for measurements on all types of modulated signals, from complex digital modulation formats, such as W-CDMA, CDMA (IS-95), TDMA and OFDM, to multi-tone and CW signals. Also, for comprehensive error correction, the sensor’s calibration factors, linearity and temperature compensation data are stored in EEPROM.